About
Reviews (1)
Mar 08, 2017
QA wont fit attachments
1 of 1 found this helpful after welding on my brackets to the backframe I tried to attach it to a bobcat bucket. It was to wide and I ground down the sides so it would fit in the flanges( approx 1/4 "). After trying to attach it a second time it turned out that the angle that fits under the top flange of the bucket was too wide an angle. I had to cut the flat bar reinforcements out of the top on both sides ang grind a sharper angle with a narrower profile to fit properly. I rewelded the bar back into place. the metal used in this is not high tensile or anything but the structural design is ok. If I had known that I would have to do all this , I would have built my own from scratch, saved money and time and had a better product.