About
All feedback (830)
- chupacabramotor (4409)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- rod-speed-racing (22941)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- enginepartsfast (10615)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- theswapmeetparts (35353)- Feedback left by buyer.Past monthVerified purchaseGreat Buyer, A+
- allendercoinc (4396)- Feedback left by buyer.Past monthVerified purchaseGreat Ebayer A+++
- transmissionjobber (36688)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Reviews (3)
Nov 23, 2023
Worked Perfectly
I used this on a 1950 Mercury, U-joint fit perfectly to the drive shaft and to a new Spicer 1310 yoke to swap from original 3 speed transmission to a later model 1970s mustang transmission.
Apr 27, 2016
i would not recommend
1 of 1 found this helpful I feel the quality of the filter is lacking. This is the first time I have ever purchased these filters. I bought a 3 pack , and the very first one I installed leaked all over inside my Brand new refrigerator. I didn't notice it until the next morning so there was quite a bit of water to deal with. I pulled it back out and noticed that the inner section where the smaller o-ring seals was actually square looking, causing the o-ring not to seat properly. I opened the other two filters and they also had a square look to them. Also, the 3rd filter was only wrapped in plastic and did Not have a paper seal on it like the first 2 did ... and the plastic wrap was open on the inlet side exposing the sterile side of the filter. If I could have posted a picture on here I would have. The other thing I noticed was that there was No Charcoal in the water when I purged the system. In the past all the other filters I bought had to be purged to remove the charcoal from the filter. I definitely Will Not be buying these filters ever again. Do yourself a favor and Pay the extra money and get a better quality filter.
Jun 14, 2018
Don't Buy !!!
1. bolt holes did not line up,had to ream out ... 2. The center flange/lip that is supposed to protrude into the harmonic balancer centering the pulley to the balancer is undersized (too small) therefore, the pulley does not seat dead center on the balancer and wobbles when engine is running causing a vibration. ... 3. Chrome was not of good quality .
*** In Short, pay a little more and buy an oem pulley instead of a cheap Taiwan reproduction, or buy an American Made Reproduction ***