About
Reviews (1)
Apr 16, 2017
Lee 6 cav molds
I have three pistol molds now, Need to prep correctly before, clean and lube hinge, pins (I use antiseeze apply with tooth pick). Sprue plate I believe its the least desirable on these molds. If not super flat from factory some edges aren't as flat as they should and causes some drag in areas on the top of aluminum mold which galls up and can catch small pieces of lead to attach in deep scratches. Thus causing sprue from full flat contact ending with some flash on bullet base, with careful temp control flash can be minimized. Need to watch any minute lead buildup and use a razor to (carefully) remove. Otherwise a good starter mold but extreme car must be taken. I also powder coat, then use lee push through sizer die, for pistol pills they rock!