My Hayward 1 1/2 HP SuperPump is approaching 13 years old. I take good care of it and finally had to replace the motor a couple of months ago. At that time, the impeller appeared to be fine. A few days ago I noticed the pump running but no water circulating. A quick check found the impeller had spun off at its hub. I ordered this kit because it has all the seals necessary along with a new impeller. What I REALLY liked was the impeller is a Hayward factory part and it is a new design. Where my original impeller had a plastic hub, this new one has a brass hub. Apparently other plastic hubs have spun off, so Hayward improved the design and this one will never fail. All the seals fit perfect too! I would say I'll buy again ... but doubt these pieces will ever fail. Shipping was also FAST! Buy here!Read full review
Verified purchase: Yes | Condition: New
I was happy to see the improvement to the impeller.. The end where it screws onto the shaft is now made out of metal and not plastic.. It was easy to install and works great, also it was reasonably priced..
Verified purchase: Yes | Condition: New
This impeller was an exact fit for the Hayward Super Pump2607X10. It was easy to install on the new Century motor...took about 5 minutes.
Verified purchase: Yes | Condition: New
It's what I needed for no hassle free installation I didn't want to stop clean the part to put on would buy from here again t Thanks
Verified purchase: Yes | Condition: Pre-owned
original part I'm replacing
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Pool Pumps
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Pool Pumps