Tried to load my new g2c 9mm 12 round clips and knew that I needed a loader. Simple and easy to use this is a top notch inexpensive product!
Verified purchase: Yes | Condition: New
Is not properly configured for the Taurus G2C. The protusion that pushes the bullets down, into the magazine is tilted the wrong way and is too far forward. The bullets in the G2C magazine tilt, with the primer end of the bullet much lower than the front. The protusion on this loader, that presses, the bullet into the magazine, is so far forward it pushes the bullets into a flat configuration which causes jamming inside the magazine. The plastic used on the loader is soft and begins to distort the portion of the loader that presses on the bullets with the very first uses. The concave porting of the loader begins to flatten as soon as it meets resistance while depressing bullets into the magazine. Because the loader is made of soft plastic and due to its improper fit for the Taurus G2c pieces of plastic are shaved off of the loader and fall into the magazine each time a bullet is depressed into the magazine. The one I received may be the exception but it is not useable as a speed loader for the G2C.Read full review
Verified purchase: Yes | Condition: New
Works pretty good. The design works okay, but it could use a little refinement. It's a 3D printed part, so some slight changes to the file might make it work a little smoother. Still a good value and MUCH better than compressing the stiff magazine spring down with your finger.
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New
This works great and I'm glad to have it as these mags are a little tough on even my manly fingers. Highly recomended
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Speedloaders
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Speedloaders