 |
Used to inject grease into new tie rod connectors. It works. Slowly. It bends easily and got stuck in my grease gun. Had to destroy it to get it our. I would suggest it be made more like an 18 or 16ga needle instead of a 20 or 22ga needle and the needle more of a blunt cannula than a hypodermic needle. This would make it more sturdy, safer to use & less likely to accidentally lodge in rubber parts unexpectedly.
Verified purchase: Yes | Condition: New
I used it on one axle then gently tried to remove the needle from the hose and the needle came off with the chuck still stuck inside the hose. That was the first and last time I used it. Needle will not fit back on the chuck. It is conservatively a bit of a flimsy design if you ask me. But is it worth what I paid for it with free shipping? Yes.
Verified purchase: Yes | Condition: New
Works great. Make sure you loosen the end of your grease fitting on the end of your grease gun to insert and remove after you tighten your gun fitting(female end) so you can move needle greaser easy.
Verified purchase: Yes | Condition: New
Easier to use than other methods, like removing the end bell to lube a motor and gets grease to where it's needed....Motors that companies claim to be permanently lubricated have shorter lives, becasue and if they not lubricated...When they don't have oil ports, these injectors can get that lube where needed....Puncture the end where the bearing is, and filler up with a little lube.......Don't over do it.
Verified purchase: Yes | Condition: New
This grease injection needle does the job. I needed it to grease the front driveshaft on my Ram 2500 4x4 and it made the job really easy.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Power Tool Lubricants
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Power Tool Lubricants
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
