CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Air Compressors
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Air Compressors
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
The old design was VERY GOOD. The pressure guages were protected and could not 'catch' on something and get yanked or bent or broken off. Same with the outgoing hose pressure control an outgoing hose mounting. VERY SOLD. The new 'replacement' design will be easy to break..It's not a design that will stand up to being thrown in a pickup or used by thoughtless amateurs. Having said this let me add that YOU CAN'T GET the old design anymore and I've seen nothing for sale on Ebay that doesn't have the same 'caveat' as I've put on this design. Again, it work FINE...It's EASY to install. The wiring diagram is VERY CLEAR. IT WILL WORK. ( Until some 'yeahoo' yanks on the output hose too hard or throws someing that lands on the pressure guages. ) It IS WHAT IT IS. Make sure your 'workers' understand that it's a bit delicate. It fails the RHINO test. The old design did NOT.Read full review
Verified purchase: Yes | Condition: New
I installed this product on a CH 11 gal compressor (OLD) and after adjusting the max PSI down to 125 from 140, it looks like it will do the trick. The cut in PSI is not adjustable, but it looks like this one is 90-95 lbs after adjusting the max pressure down. If this were a stationary compressor, I'd rate the product a bit higher, but since it's on wheels, this makes me nervous. The hose connector fitting (which wasn't supplied, by the way) protrudes 6" out from the connection to the compressor, and I feel like I need to build a cage around this thing to support/protect it from an inadvertent bump. Shop around- you can get one that actually has a couple of hose connectors included for a lot less.
Verified purchase: Yes | Condition: New
Had to re-build my old compressor when the controller started leaking. This kit did the job, and worked as described, fitting perfectly and was a breeze to install. My compressor is "good as new" again and I have used it several times since with good results.
Verified purchase: Yes | Condition: New
The original C&H pressure switch started leaking. My effort to dismantle it just proved how inferior and unrepairable the original design was. Found these marketed as replacements. Easy install. Component quality isn't the best but better than the original. Been using it for several weeks now. So far so good. Just wish they weren't so pricey. Have two other compressors that could benefit from a conversion, but at $60 plus a pop will wait.
Verified purchase: Yes | Condition: New
It came with everything needed to install it properly. The fittings even had Teflon tape on them. The preset pressure was spot on. Although as a unit, it isn't as neat and compact as the original, it is out of the way of electrical cords and air hoses.
Verified purchase: Yes | Condition: New
