CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Shotgun Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Shotgun Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
the loop on the back of sheld needs to be cut down in length and thickness if not slide will not cycle it hits on the spring loaded rods on the inside of the fore grip dremil it to half its thickness and take off some length on both sides of the loop on back of heat sheld so action will work and as allways check your fuction it is your life make shure it works if not get rid of heat sheld. 'SHOOTEM UP SPITEM OUT RAW HIDE"
Verified purchase: Yes | Condition: New
I recived this heat shield realy fast!!! And packaged ok. But... The vent holes were not debured and had sharp metel shavings on bottom side. the screws could have been longer and are not standard or metric threads??? i went to 6 different hardware stores and could not find any that matched only original screws work. Barrel clamp where the screws go is so thin i think recoil will most likely break the clamp. And lastly this is NOT ANODIZED it is a spray on bed liner that you can buy at home depot or walmart. This is not for every day use (not for law enforcement use) but will be ok for a home defence shotgun that doesn't see much use. Maby i got a lemon out of the bunch try your luck. I decided to try it but not on my 500 i didnt want to scratch my bluing so so i cleaned up the sharp shavings (not very easy with truck bed coating over them) and modified it to fit my 930spx i haven test fired yet but dont expect it to last long but it dose look good now. Time will tell. Seller did offer to accept it as a return. seller is very good!!!! I know my stuff this review is honest and not written by a couch Commando I hope this review helped I don't normally leave reviews for products good or bad but felt it was necessary this time I didnt know there actual store is a paintball shop Read full review
Verified purchase: Yes | Condition: New
The product is well made but the screws needed to hold it onto the barrel are to short for the Tactical with breacher barrel. A little longer screw would do it. I will have to either find longer screws or get another heat shield entirely.
Verified purchase: Yes | Condition: New
Be CAREFUL becase the PICTURE shows you will get everything you need t oattch it to your gun however you will need the "O' style bracket that goes over your barrel and THEN the light will attach to it....on the side on my Mossburg ...the O style bracket was TOO THICK to mount as pictured....miselading and confusing
Verified purchase: Yes | Condition: New
got this heat shield for my Mossberg 500 12 gauge shotgun and it fits and works like a charm! it's easy to install and it's well made. I'm very happy with it's performance and I highly recommend it.
Verified purchase: Yes | Condition: New
