 |
This is the second replacement one I've ordered. The mounting bracket on the original and the first replacement both got broken after pulling our boat too far into the lift. The plastic bracket is kind of cheesy. It would be helpful if I could just replace this part instead of the whole trandsducer, which works fine.
Verified purchase: Yes | Condition: New
Probably good in certain applications but not for mine. 22' Tri-Tune pontoon boat mounted on the mfg provided plate at the back of the boat on the pontoon. At about 10mph the water around the sensor gets pushed away and depth readings go to zero. Made an adapter plate to drop the sensor lower by about 4" which put the bottom of the sensor below the 'toon' still same problem. I will be looking into Humminbird exchange program for a different type of sensor. Talking to Humminbird on the phone was a good experience.
Verified purchase: Yes | Condition: New
Very simple to install and plug into the main unit. This unit is a lot tougher than the original one as the mount has been made stronger. Overall a great replacement unit.
Verified purchase: Yes | Condition: New
Even though this is advertised as a "7 pin" connector there is only 3 pins. While it works with Side imaging units It will not side image. It only does the standard functions. I have a Hummingbird 899 SI HD. It doesn't HD or SI . Also Broke the transducer mount first time I had it on the water due to weak mold. Not as durable as the original that came with my unit.
Verified purchase: Yes | Condition: New
Bought to replace damaged original . easy install and replaced all my original functions. Very satisfied.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Fishfinders
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Fishfinders
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
