It does what it says it supposed to do and it does seem to be precise but the dial is too loose and there’s no way of locking it down. I was able to put bits of paper under the dial to increase the friction and keep the dial from moving when I brushed it with my hand. There needs to be a way to lock the dial down. You also need to understand that the graduations on the Dial are not actually correct, they just show the relative position of the plunger not the actual amount of powder being dispensed. For instance if you turn the dial to four it will dispense about six grains of powder. But if you move the dial up from one to two it will increase the amount of powder you’re dispensing by one grain so the numbers on the dial are precise but not accurate.
Verified purchase: Yes | Condition: New
Micrometer works good but it will only get your powder charge back "in the ball park" when changing loads. Fine adjustments will always be required even when using the same powders.
Verified purchase: Yes | Condition: New
For those that load multiple calibers on your progressive loader, this is the best thing since sliced bread! Changing powder charges is so much faster and easier! Well worth the meager investment.
Verified purchase: Yes | Condition: New
This works well, and settings are repeatable, however, the scale printing is Terrible. With good eyes, good lighting, and even glasses, it is nearly impossible to see settings. The scale and numbers are far too difficult to read! Seems an easy fix, for an otherwise good product, that should have been addressed in production
Verified purchase: No
Save me a lot of time going to different load sizes. Gives me a starting point.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Presses & Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Presses & Accessories