 |
Great factory product and came within a relatively fast time! Took these out to the range for some well needed shooting. Besides a few FTF, which I am sure happened do to breaking my new riffle in, they seemed to work as intended. Will be ordering more soon.. The more mags, the merrier!!
Verified purchase: Yes | Condition: New
First the mags are actually the lowest price I could find and that's great but it DOESN'T mean it's a great value! Hell no! Way over priced but what's one to do? They are a little tight going into the mags well and don't drop out like it should, I may have to take crocus cloth or really fine wet dr I do recommend these though and think they are of good quality but one never knows until they know if you catch my drift but by then it's usually to late...y sand paper and take it down a little!
Verified purchase: Yes | Condition: New
I ordered these to try in a couple AR7 Charter Arms survival rifles. I had failure to feed issues. They seem to work fine with the 50 or so rounds put through them. The spring holds the cartridge straight so it doesn't pop up and jam. Only issue I have with them is they are a snug fit and don't drop free without pulling them out. That doesn't bother me as long as they feed. So if you have feed issues with your older AR7 rifles, Give them a try. They seem to be working fine for me so far. A little tip for stock Charter Arms mags. Bend the feed lips a little at the tips to keep the cartridge straighter as it leaves the lips. This helps but may take some playing to get just the right bend.
Verified purchase: Yes | Condition: New
The magazines are very well made. Good fit and finish. They actually appear to be sturdier than the originals. My AR-7 is about 40 years old. They snap right into place and the ammo feeds well. A great value. They arrived in a timely manner and were well packaged. I'm one happy camper.
Verified purchase: Yes | Condition: New
These are great magazines. If you have the Charter Arms rifle, keep in mind they may not exactly fit. Mine were 0.5mm deeper than the factory magazine. This was easily solved by shaving a little metal off of the front of the mag. DO NOT SHAVE down to where the plates meet, that would be too much. Break out the calipers or visit a gunsmith if you are not sure. After a little shave, mine work perfect and they solved the feed problem that is inherit to the model. Again, I would highly recommend and will pickup more in the future.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Firearm Magazines
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Firearm Magazines
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
