Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Resin Craft Molds & Supplies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Resin Craft Molds & Supplies
This is the first time I've used this product and I'm very pleased with the results. It was much cheaper than buying a similar one in my lcoal store so waiting a couple of days for it to arrive was well worth it. I plan to continue to use this product for my future resin jewlery projects. One thing I did notice was that it started to set within a half hour.
Verified purchase: Yes | Condition: New
I don't know exactly why but this resin leavea a visible dilm in a hardened piece . I've mixed longer in different ways to see if it's something I'm doing but same result. It's good for small pieces the film isn't as visible but for clear pieces I don't recommend or for canvas work .
Verified purchase: Yes | Condition: New
I did a lot of research on epoxy before purchasing any particular brand. I hit a gold mine with this product. Simple to use and the secret to blend is putting your container in warm water while stirring. I have made a lot of coaster projects with objects or alcohol ink and they always turn out beautifully. I am now getting ready to make my fourth order. So yes, I highly recommend.
Verified purchase: Yes | Condition: New
I used it to make a kind of "micarta" using fabric. I had plenty of time to work with it before it started to set, so that was a good feature of 7050. It cured clear. There were small air bubbles, but for my purpose it didn't make any difference. There might be a way to mix it more carefully to reduce bubbles (I don't think you can avoid them completely).
Verified purchase: Yes | Condition: New
I've used epoxy resins for about 3 years now and I've used a couple different formulas. I normally use a vacuum degassing process to remove air bubbles but that just didn`t seem to work with the 7050 formula- it never did settle to a clear liquid in my container after several minutes. Frustrated, I just poured the mix into my molds to see how bad they would turn out. I could see bubbles in the molds and the mix was starting to cure so I gave them little hope. Amazingly, when I came to look at them several hours later most all the bubbles were gone and they were crystal clear! I was stunned good! After 24 hours they seemed very solid but I still did my post-cure of 24 hours at 150 degrees F. These look fantastic, hard and clear. I usually mill my molds on a lathe, if that works well then I am hooked on this product! I should mention it was cold (about 50 degrees F) where I performed the degassing, MAYBE that is why the formula acted so unexpectedly. I have high hopes for using this product, so far it has exceeded my expectations. I may have to alter my past processes to work best with this product.Read full review
Verified purchase: Yes | Condition: New