 |
I threw my Milwaukee 3/8 power wratchet and the head part exploded . Never do that. There are tiny pins inside that disappear as well as a C- Clip. The replacement works great but is somewhat difficult to assemble. Center the pawl that reverses the direction of the head and use a socket to hold the part in while pushing down the C- Clip. You will never get the clip in the groove unless you support the back side. Works great again.
Verified purchase: Yes | Condition: New
Unfortunately parts wear on this type of tool so they must either be repaired or the whole tool replaced. I have found deals to replace the bare tool for $100 or spend about $30 for a simple to install part to repair it. Being an OEM part I trust the quality and fit. I'm sure eventually I will have to replace the tool but for now the motor is good and it was only slipping so repairing it makes the most economic sense. It only took 5 to 10 minutes and now my ratchet works like new.
Verified purchase: Yes | Condition: New
Used for Milwaukee (2560-20) M12 FUEL 3/8" Extended Ratchet to replace broken 1/4" anvil. Works perfect and is a lot stronger than original 1/4" anvil. I have the (2557-20) M12 FUEL 3/8" Ratchet, but this long reach ratchet with the upgraded 3/8" anvil is my go to now.
Verified purchase: Yes | Condition: New
I have had the ratchet for seven years and used it many hours . The part listed above finally broke . It works as it did when it was new after installing the new head .
Verified purchase: Yes | Condition: New
Perfect fit, works great. Liked that it included washer and snap ring.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Impact Wrenches
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Impact Wrenches
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
