The EDM-4000B unit is a very portable unit capable of penetrating almost anything electrically conductive. I have used a tubular electrode to cut thru exhaust valves made of high temperature resistant material with ease. The cutting rate using a 3/8” diameter solid electrode in the otherwise difficult machining effort was impressive, 1/4” deep in five minutes! No need to clean off surface or grind to bare metal, this thing burned thru everything! The water electrolyte used is plain tap water without any additives and as a side benefit there is no heating effect to cause damage or distortion. I’m using this to remove small 1/4” steel studs from aluminum castings. Broken studs are “drilled” with hexagonal electrodes and removed with hex drivers. Accuracy is within .015” of electrode outside diameter. It could use a few more different length extensions to support the cutting head actuator but they are simple round bar with a short threaded section on the end. Oddly, the actuator’s mounting female thread is different from the magnetic base support’s. Setup is quick and easy taking less than five minutes from completely disassembled to ready for operation. I’d like a storage tray to fit inside this unit with the self contained storage box as it does not have a pull-out tray. Using a drill chuck to hold the electrodes is genius but not easily adapted to flat electrodes. A small threaded clamp adapter is needed for that. Unit worked well on 120VAC 20A circuit. Not sure how this is rated for 3000W cutting power but I’m glad I did not purchase the cheaper 800W unit. In short, if you need or want to punch a round or odd shaped hole in metal this machine will do it with ease.Read full review
Verified purchase: Yes | Condition: New
Awesome piece of equipment to have. Sure we wont use it often but it will make life easier when we need it!
Verified purchase: Yes | Condition: New
Works great and has been a life saver a few times
Verified purchase: Yes | Condition: New
very good quality. used it on engine, broken studs (volvo penta) m10 & M8 studs. even a broken tap succsesfully removed. Emma liu is a very good on service and quality! recomend her on the highest level!
Verified purchase: No
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Electrical Discharge Machines