 |
Well I spent weeks searching for a solid case. there were full towers old school towers with drive bays towers that were all glass, with wheels, all metal etc, etc, some were highly futuristic and highly expensive. they were all missing some key features that I absolutely insisted on and not for a small fortune. I went ahead and chose the best tower for a cheap price. Honestly I didn't expect much for a tester case. what I got was a truly solid mid-sized tower when I opened the box I got a tower with solid foam packing to protect it. a tempered glass panel with plastic film protecting both sides. the tower has a nice flat black finish through the whole tower and there are no metal burrs around the edges so assembly inside was very nice FYI: I would not recommend putting an matx into this case I don't think it would fit? A bag with zip ties, screws and motherboard mount risers, I ordered a bag expecting that this tower would give me nothing. so when I got them in the case I felt kind of stupid - and ripped off for the 7 bucks I paid for those. The case is very spacious because I fit my MSI z370a pro in and there's still a lot of room it only has one 5.25" bay for an optical bay but that's fine because that's all I need for my build (my primary req for a case. or you could use it for some other addons if you don't care about an ODD?) the space is great, since you dont have a rack(bays of wasted space for multi 5.25's there is 2 bays with plastic quick loads for 3.5" hdd's on the bottom in front of the power supply for anyone who hasn't bought ssd's or moved over smaller 2.5" drives there is 2 spaces for 2.5" drives on the wall by the motherboard and you can install another in the base above the power supply - as there is a distinct 2.5" dent in the bottom body for one. the front has 2 2.0 usb and 2 3.0 usb a springy nice reset button and a nice large clicking power button this space where a bay rack would traditionally be is one of two places to install a water cooler. I installed 2 red led fans the front in mine instead. I may put one in the roof? the room in the roof would need a very thin radiator so best to install on he front of the case. there is the one fan that it comes with mounted in the rear. a tempered glass door (not plastic those scratch when cleaning) there are two magnetic dust filters one on top and one on bottom. they fit perfectly there are 7 slots for expansion cards which is nice if you have things like a custom sound card or want to add NVME ssd's to your system. wire management was good. some drilling may be necessary to route certain wiring (based on your motherboard) I had to drill a couple holes because I wanted my wiring tight and clean. then zip-tie it all down note : don't zip tie just yet (use wire ties like bread ties or rubber bands until you are certain you are happy with everything) if you don't like a certain cable placement you will have to waste the ties and time the negatives: none of these are really negatives but - a few more cut outs for cable and mounting - can drill cut and sand them yourself but it will ruin the flat black finish I would have liked a few more zip ties a few more hdd mounting screws. if you lose any then you come up just shy of fully mounting 2 hdd's I would have happily paid 3$ more for 6-10 more hdd screws so all in all this is one of the best towers I have ever had and it was 50 bucks. Read full review
Verified purchase: Yes | Condition: New
This case is perfect for me as since I just wanted to put it together without too many wires showing through the glass. There's a compartment separated behind the board that allows for some great hiding of them and drives. I'd give it an 8 out of 10, as it made cable management easy for a dunce like me.
Verified purchase: Yes | Condition: New
This very low priced case made for a perfect build. The wire routing was easy. I've built cases that cost more than 10 times this price and not been as happy. I used red case fans and a dark shadow CPU fan to give something to see thru the glass side. One front fan, one top fan, and the included rear fan gave great cooling.
Verified purchase: Yes | Condition: New
This case is just what I needed for my mid sized build. Plenty of room for all my components and cable management was a breeze. Stylish case with easy access to everything.
Verified purchase: Yes | Condition: New
Great looking case. Even the dust filter on top screams quality. The mesh and glass side panel for the price can't be beat!
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Computer Cases
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Computer Cases
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
