Purchased another one first. I was disappointed with it because it didn't come with the quick disconnect fittings and only came with screw in stims that didn't even thread in correctly and basically well, had to return and refunded. Ordered the one from champion and it was only $50 more but came with everything to make it an easy install. Only had to cut back 3/4" on the bottom of my fan shroud because of it being a 3 row. Took like a min. with the multi tool. Just be sure to add thread lock to the quick disconnectors and do this before installing it with it laying down! Easier for the o rings to set right upon reinstalling them. Other than those two things. The best in my opinion to keep my H2 running cool in the desert heat. You might want to replace everything that goes with it at the same time. Thermostat, hoses, and maybe the resivor if it looks kinda grimy on the bottom.
Don't take it to a mechanic, it will run you about 700 for labor because of the " modification" that has to be made for it! Yeah, thats what I was quoted! 4.5 hours later, I had it all done! Just remember to burp the system and check for small leaks around the hose clamps and connectors. Test drive a few times and always double and triple check!
Appears to be very nice piece I installed it and had to cut about a quarter inch off of the plastic shroud on the very bottom not really a big deal and I would suggest using Teflon tape on the cooler fittings or thread compound engine runs much cooler trans temp stem oil pressure up a couple pounds so far very nice it's only been in a week everything was right where was supposed to be installed very nicely