Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Printers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Printers
Pros Dual extruder, decent software, wireless (although slow if used over WiFi), 200 or 70 micron resolution, and pretty easy to setup. Prints very well. I've been impressed by the print quality thus far. Neutral This printer uses glue on the printing plate (which is detachable btw, so that's nice) to anchor prints instead of a heated table. This is both pro and con, as it is much safer to print with, but requires a water soluble glue. Cons Must buy filament spools from manufacturer. This can't use any cheap filament. The spools literally have DRM built in. However, the spools also have the extruder attached, so there is literally no worry of that the extruder might get messed up, and maintenance is really really a minimum. Only drawback is the price of spools.
Verified purchase: No
The 3D printing quality is very high and the cost is one of the best I've seen. The extruders are not the best in this printer but can by fixed like any other 3d printer. The Cube 3D is not compatible with generic cartridges an original are expensive in comparation. Personal rate: 3.8/5
Verified purchase: Yes | Condition: New
The 3D printer is a great machine. You will need the 3D software for it from 3D Systems ( it is free ) New reels of filament is recommended. They can be bought at 3D Systems.
Verified purchase: Yes | Condition: New
If you need this printer. You have to have the software 3d creating. No software. You can do nothing. This printer come without software. So i dont recommendation
Verified purchase: Yes | Condition: New
SO FAR SETUP HAS BEEN EASY AS CAKE. DID A TEST PRINT AND FOLLOWED DIRECTIONS AND HAD NOT ONE PROBLEM. A TAD BIT NOSIEY BUT EASY TO OVER EAR.I WOULD HIGHLYYYYYYYYYY RECOMMEND FOR 1ST TIME USER OR ANYONE. JUST AWESOME
Verified purchase: Yes | Condition: New