 |
The End Mill's are of good value and give an excellent finish to the material that I was milling. I will purchase more of these in the near future. I think these Carbide End Mill's are some of the best that I have used. I also like the fact they are Made In America.
Verified purchase: Yes | Condition: New
at first i thought it was me or my machine causing these to break quickly. but i have had my spindle taper ground for 100% taper contact and the runout is 0.0001". these bits still won't hold up. i talked to the factory that made them and their recommended feeds and speeds for mild steel are 100-160sfm with chip load of 0.0015" per tooth. snapped as soon as it hit the metal. they are cheap but they don't last any length of time. some will break instantly with the same settings you ran 3 parts on the previous bit. best i have done with them is at 250sfm and chip load of 0.0006".
Verified purchase: Yes | Condition: New
I used this end mill to bore a 3/8 flat bottom hole in a stainless plate. I lived the cutting tool with tap magic and I accomplished the job effortlessly . Joe
Verified purchase: Yes | Condition: New
Rips iron castings like a hot knife through butter. Great cutter for the price. I will buy more. Thanks!
Verified purchase: Yes | Condition: New
This mill is good quality .It held an edge just fine.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in End Mills Accessories, Extensions & Storage
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on End Mills Accessories, Extensions & Storage
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
