 |
Definitely what my Beckett burner boiler needed. My only gripe is the label - must be made in china, since all the lettering washed right off after cleaning up residual oil with brake cleaner. Better take a picture of this picture if you want to service it in the future. My old one was 20 years old, and the internal check spring very weak, causing afterburner and drip. With this new one, I can hear the flame go out before the burner even finishes spooling down. Time will tell if this one is as robust as the original.
Verified purchase: Yes | Condition: New
Replaced a 20+ year old Suntec A2VA-7116 burner oil pump that had problems adjusting pressure with this new one. I also had to adjust the pressure on it from 100 psi to burner default 140 psi and so I used a pressure gauge that was part of a pump testing manifold develped by Mitco where one can check both the pump pressure and vacuum readings. After some smoke level and draft adjustments my oil burner runs without any problems so far.
Verified purchase: Yes | Condition: New
Perfect fit made for an easy install. Ports are clearly marked so there will be no confusion which line goes where. Burner fired after only about a two second line bleed. If your fuel line fittings are in good enough condition for re-use, you will not need anything else except for perhaps some fuel-compatible thread sealer. All that said, installation by a professional licensed technician is recommended and in most cases required by local codes. This unit is NOT compatible with fuel blends with higher than 5% biodiesel content.
Verified purchase: Yes | Condition: New
Exact replacement for Mother in law's furnace. Her furnace broke in beginning of winter, was very cold (freezing), a snow storm was coming and she couldn't afford a new furnace. My hubby ordered this, replaced it and by the grace of God, it worked! His 70 yr old Mom had heat!!
Verified purchase: Yes | Condition: New
With the cost of verifying environmental compliance I wanted a new pump that would give consistent performance for a very long time. I saved the old pump as a backup spare part.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other HVAC & Refrigeration
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other HVAC & Refrigeration
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
