Original JB Weld more than lives up to it's reputation. It's extra strong for those repairs that don"t have to be put back into service the same day since it requires 24 hours for a full cure. Just the ticket for difficult repairs requiring maximum strength and durability. The twin 4 ounce tubes are a great value and provide enough material for many repairs. Will be my go to for repair epoxy.
Verified purchase: Yes | Condition: New
JB-Weld is a bonifide tool. This original formula takes a long time to set and cure, but the strength and temperature limit is double the Kwik version. I need to have both available. When in doubt, use the original and sit it out until it cures. It helps if the surface is roughed up a bit so it won't pop off the surface. I've repaired two tables with it recently that needed to take some abuse. I also repaired a treadmill drive wheel six years ago with it and now have over 7,500 miles on it. There is no way it would every fail. If the application is right, this product is bullet proof.
Verified purchase: Yes | Condition: New
Very good strong epoxy for a variety of uses. The original is stronger than the quick setting type. I have used it for years on many different repairs and always found it to be of high quality.
Verified purchase: Yes | Condition: New
I've used JB Weld for several years now with very good-to-excellent results. I am satisfied that when it it is used CORRECTLY, and in the right places, that my repairs have been good and will hold up well. That means that you must do the surface preparation as they tell you, without skipping any steps. Not sure about the user with the failures reported when the repair was on a grease pipe. I can only imagine how difficult it would be to get the pieces TRULY clean. Also, JB Weld is really an EPOXY. There is no metal penetration as you would get with actual welding, don't expect to put some on the ends of 2 pieces of pipe and stick them together and then have it hold as actual welding would do. My most successful applications have been using it as a bonding agent between replacement body panels, augmented by countersunk head rivets. Choose your applications correctly and you will be satisfied.Read full review
Verified purchase: Yes | Condition: New
JB Weld is the strongest available epoxy (according to several reviews) It takes a whole day to really cure but then you have an epoxy that will stick to almost anything and the material it adheres to will give before the epoxy. (except some metals - of course) I have used it to replace plastic parts with excellent results.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Multi-Component Epoxies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Multi-Component Epoxies