 |
Skeptical about dealing your door to your pellet grill. Have no fear, the material will fill the void. I applied this seal to a brand new pellet grill door. Make sure the application area throughly clean and free of any contamination. You get only one try with this. Where is applied is where it will stay. If you are careful and methodical in your application, you will have a factory look and no smoke or heat escaping around the lid door. I would advise you occasionally wipe the inside of the lid clean with a paper towel after using your grill to remove any accumulation of oil or grease. Enjoy your pellet grill.
Verified purchase: Yes | Condition: New
Just got an Oklahoma Joe Bandera that does a good job but like most of the mass produced smokers doesn’t seal well. Purchased these to put on the door and on the fire box lid. Cleaned both very well and installed. Now I no longer have issues with air leaks. Will turn a good smoker into a great smoker!
Verified purchase: Yes | Condition: New
I ordered this for my side box smoker, I had small gaps in the metal to metal closure on the lid but this tape sealed it perfectly and now I’m not losing heat or smoke anywhere but the stack. Temps are more even and have greater heat control. Thanks Great product!
Verified purchase: Yes | Condition: New
works great, make sure to sand off smoker's paint of where this will go, and it will stick better than if you just stuck it there with paint.
Verified purchase: Yes | Condition: New
It done the trick my pit now smokes out the stack instead of the doors
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Barbecue & Grill Replacement Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Barbecue & Grill Replacement Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
