CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Pressure Washers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Pressure Washers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
My Honda GV160 powered pressure washer had a 3 1/2 in shaft. I had to use 3/8 by 1 in spacer with a 3/8 in brass split lockwasher with 2 1/2 in bolts to mount pump. Due to the configuration of the motor, the pump exited out the back instead of the side as the previous pump did. Luckily there was an extra set of axel holes about 1 in lower in the frame. I moved the axel and had plenty of clearance to attach the hoses. I will probably go back with 3 in bolts to mount pump. The 2 1/2 in bolts are a little short. The pump operates good. Much better than original pump. I found parts at Ace Hardware for about 20 bucks. Only time will tell how long it lasts.
Verified purchase: Yes | Condition: New
The pressure seems better than the original one on my Brute pressure washer. It's universal for many models. I had to put some washers between the mounting holes and the bottom of my pressure washer for proper fit. This also required me to install longer mounting bolts which I had in my garage but are super cheap if you have to buy some.
Verified purchase: Yes | Condition: New
This pump bolts right on the Husky HU 80931 washer in ten minutes! Old pump was junk and did not last, but this one looks pretty heavy duty. Works great, better pressure than original. Be aware that hose fittings now face out the rear of the washer, but that is no issue in use. Don’t chuck the washer, buy this pump! Just make sure you save the “key” from the shaft of the old pump, as one is not included.
Verified purchase: Yes | Condition: New
I only try this unit out to see if it fits my Troy Bilt 2200 psi power washer, it install with no problem no shim was need. Tested it out for about 10 minutes because it December and it cold out it seem to be a good product. I don't know how long it will stand up until I try it out in the spring.
Verified purchase: Yes | Condition: New
Works very well. I noticed the mounting feet were 1/4” less depth, so I picked up 1/4” spacer washers (3), and it mounted perfectly. Pump has to be dropped to change engine oil but it’s no big deal, especially with the spacers!
Verified purchase: Yes | Condition: New
