Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Smart Home Electronics
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Smart Home Electronics
The visual appearance and functionality, as with all of aeotec's products, is very very nice. But I've seen this with Arotec before, their practical design leaves a bit to be desired. The enclosure is not waterproof and if locating outside, it must be installed in a secondary enclosure. The switch's enclosure will not accept conduit clamps, so you will need to use romex or install the unit in a junction box if you plan to use it with individual conductors. If you do use romex, plan to be amazed at how little room there is in the switch to actaully terminate wire. The included rubber grommets are pretty much useless as they deform from the memory of the wire... Also included are crimp style ring terminals; unless you want to save them for a 12volt project, immediately throw them out! You should not be using this type of connector unless it's soldered to the wire. So, great switch, as it functions with zwave and has power monitoring, but plan on placing it in a junction box if you want to wire it up to meet code or if you're planning on placing it outside. PS... make sure to use a plastic junction box as an all metal enclosure may impede the zwave performance.Read full review
Verified purchase: Yes | Condition: New
Works just as described, easy set up. Yes it could use heavier connection points, but it connected easily.
Verified purchase: Yes | Condition: Pre-owned
It is larger than it looks in photos. It makes a satisfying clunk when switching. I installed it for a water heater to turn it off during peak pricing hours. The primary weakness is that it failed communicate with the hub when inside the breaker box (it worked fine when the cover was off), so I had to mount it on the wall underneath.
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New