Had just put a brand new battery into my lawnmower. It was the same brand battery that I just got 3 years use out of. The switch worked great! After a few weeks the mower got harder and harder to start. The first switch failed. The Company was very kind and sent a new switch. I installed it and the mower still had a hard time starting. I bought another better battery and it cranked right up. The first new battery I had bought was defective. I feel this might have caused the first switch to fail.
Verified purchase: Yes | Condition: New
These push button starter switches are poor quality. The one I received did not work. Spend a little more and get a name brand heavy duty one.
Verified purchase: Yes | Condition: New
I use it to put two wires on it . hot to solenoid battery side and other wire to switch side of solenoid. After pulling coil wire out or fuel pump fuse out. Works well for bumping engine over when you have no help. On mower or auto. Just use heavy gauge wire and maybe a 15 amp fuse on the battery side wire . Two alligator clips for connecting and your set. Hope this helps someone. Ronald4027
Verified purchase: Yes | Condition: New
Switch was a perfect size to get my Radial Arm Saw working. Needed a hi current switch to connect my Starter winding get my saw running. The centrifugal switch burned out and after 25 years parts are no longer available so I connected a Manual switch to start the single phase motor. Worked like a champ. THX
Verified purchase: Yes | Condition: New
Works great. For my application on my boat, the tightening nut could have been a small diameter. Socket wrench would not fit in the receiving hole so I had to tighten with needle nose pliers. The switch I replaced had a much smaller holding nut and did the job fine.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Pushbutton Switches
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Pushbutton Switches