Philmore 12V 50A Push Button Momentary Starter Ignition Switch

SYDCO-USA (4444)
99.3% positive feedback
Price:
$9.97
+ $8.99 shipping
Estimated delivery Sat, Dec 27 - Tue, Jan 13
Returns:
14 days returns. Buyer pays for return shipping. If you use an eBay shipping label, it will be deducted from your refund amount.
Condition:
New

About this product

Product Identifiers

BrandPhilmore
MPN3012475
GTIN0038975314754, 0627434100344
UPC0038975314754, 0627434100344
eBay Product ID (ePID)23019373788

Product Key Features

Current TypeDC
Operation MethodOn/Off
Fuse TypeSwitch
Termination TypeScrew
Contact MaterialCopper, Brass
FeaturesIlluminated, Heavy Duty
Number of Positions2
Maximum Amperage50 A
Current Rating51-60 A
TypeMomentary Switch
Contact ConfigurationSingle Pole Single Throw (SPST)
Coil Voltage11-20 V
Model30-12475

All listings for this product

Buy It Nowselected
New

Ratings and Reviews

4.7
103 product ratings
  • 90 users rated this 5 out of 5 stars
  • 6 users rated this 4 out of 5 stars
  • 3 users rated this 3 out of 5 stars
  • 0 users rated this 2 out of 5 stars
  • 4 users rated this 1 out of 5 stars

Would recommend

Good value

Good quality

Most relevant reviews

  • Top favorable review

    Works Great Good Value!

    Had just put a brand new battery into my lawnmower. It was the same brand battery that I just got 3 years use out of. The switch worked great! After a few weeks the mower got harder and harder to start. The first switch failed. The Company was very kind and sent a new switch. I installed it and the mower still had a hard time starting. I bought another better battery and it cranked right up. The first new battery I had bought was defective. I feel this might have caused the first switch to fail.

    Verified purchase: YesCondition: New

  • Top critical review

    Cheap switches

    These push button starter switches are poor quality. The one I received did not work. Spend a little more and get a name brand heavy duty one.

    Verified purchase: YesCondition: New

  • Handy diy tool

    I use it to put two wires on it . hot to solenoid battery side and other wire to switch side of solenoid. After pulling coil wire out or fuel pump fuse out. Works well for bumping engine over when you have no help. On mower or auto. Just use heavy gauge wire and maybe a 15 amp fuse on the battery side wire . Two alligator clips for connecting and your set. Hope this helps someone. Ronald4027

    Verified purchase: YesCondition: New

  • Perfect product for a Push Button ,, Normally Open contact.

    Switch was a perfect size to get my Radial Arm Saw working. Needed a hi current switch to connect my Starter winding get my saw running. The centrifugal switch burned out and after 25 years parts are no longer available so I connected a Manual switch to start the single phase motor. Worked like a champ. THX

    Verified purchase: YesCondition: New

  • Good quality switch

    Works great. For my application on my boat, the tightening nut could have been a small diameter. Socket wrench would not fit in the receiving hole so I had to tighten with needle nose pliers. The switch I replaced had a much smaller holding nut and did the job fine.

    Verified purchase: YesCondition: New

  • Momentary push button switch

    I was looking for a momentary switch that was easy to push as I needed it for a seniors call button. This one works well for that and I'm very happy with this purchase.

    Verified purchase: YesCondition: New

  • Outboard Kill Switch

    I rigged this switch up on an old Mercury Outboared. Its heavy duty enough to work and fits the hole just fine. The rubber cap makes it relatively weather proof too! I ordered another for a spare just in case. Thanks!

    Verified purchase: YesCondition: New

  • great product, cheap price.

    I am using one as a kill switch for an outboard motor, and the other one as an electric starter button saving over $90. dollars john

    Verified purchase: YesCondition: New

  • Starter switch large Rc motors

    Excellent design correct size. Works as imagined.

    Verified purchase: YesCondition: New

  • quality with good price

    I ordered several of these push button switches. They will handle about 50 amps of 12 volt DC power. I used 2 of them to rewire the cranking system on my diesel 4x4 tractor. One button powers the glow plugs and the other button powers the starter solenoid. My key switch had become dysfunctional and a new one was about $75.00. This is a "cheap fix" at 15% - 20%% of the cost of a new switch.

    Verified purchase: YesCondition: New