Late model Harley Bagger with 130mm wide tire. Tire gets lodged in the front "V" upright and makes it very difficult to get out. Front upright has only one bolt and it holds the upright up off of the base, like a pivot point. The horizontal pin and hole clearance for the front upright does nothing and the front end can lean left or right untill the corners of the bracket bottom out from pivoting. Too much for comfort with a $30k motorcycle. The hole should be higher in the bracket so it is fully supported by the base and the goofy side slots and pin setup need to be re-thought. The rear pivoting bracket also catches the rubber and grabs it in place like a side clamp. It is difficult to get into and the feet won't hold it in place. You will need to anchor this. I had to jack the whole bike up and pound this off the tire with a dead-blow mallet. I had high hopes and tried various arrangements (since there were no instructions other than where the bolts go) but I had zero success.Read full review
Verified purchase: Yes | Condition: New
I purchased this for my Indian Chieftain but right off the bat it needed to be modified for the fender or it will mess it up. Once that was done I had to play with the the pin you put in for the wheel catcher to close and it will just side as you try to roll the bike in. It works you just might have to modify it for your bike you can't beat the price.
Verified purchase: Yes | Condition: New
Seems kinda flimsy. I have a 900lb HD. You have to drive it up and over a thick pin to get it in to position, which means you have to give it some gas and use the clutch. Once in, it takes three people to push the bike back out, because it has to go up and over that pin. I used it once, now it just sits in the garage.
Verified purchase: Yes | Condition: New
Used on a trailer with three other bikes. Mine was easy to install and made mine the most secure. Now my friends are buying one.
Verified purchase: Yes | Condition: New
Easy to assemble..easily adjustable..affordable..supports a sportster 1200 just fine when adjusted properly..great product for the price.
Verified purchase: Yes | Condition: New
Product is sturdy, it holds my Roadglide 2020.. Cons: My front wheel gests stuck, so its hard to pull the bike back...
Verified purchase: Yes | Condition: New
Well made, Perfect and work great. If you need a bike stand, Buy one from this Top Seller. They are strong and if you have, ride, race or collect Motorcycles, this is a must. You will be satisficed with this and probably buy more. Highly Recommend.
Verified purchase: Yes | Condition: New
Solid product, very stable with large bike on it, easy to use and store.
Verified purchase: Yes | Condition: New
I bought this to trailer my heritage softail...its awesome, my buddy bought a stand for his for 200 dollars more than this one and i find this one stronger and more stable than his...great buy!
Verified purchase: Yes | Condition: New
This chock has made it possible to get my jeep and Harley in the garage ... great!
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Wheel Chocks