 |
You do have to spend some time aligning everything up and rotating the pin a bit as you clamp down on it. Usally I get the pin in the machine with one click line it up, then inset the wire. Does the job.
Verified purchase: Yes | Condition: New
It is a nice tool, however it does not fit the AMP .093 pins (AMP number 350705-1 and 350550-1). The dies are too small and it just crushes the pin. The second pin that I tried to crimp is still stuck in the crimper. I will dig it out when I have some time. It might fit the smaller pins, I have not tried them yet. I will have to work on the dies to see if I can make them work. It is still much less than the AMP/MOLEX crimper that sells for $250-400.00.
Verified purchase: Yes | Condition: New
It's OK, tough to manipulate the release after the crimp.
Verified purchase: Yes | Condition: New
Great, does what it is supposed to do. Crimps a .062" pin in one pass
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Hand Crimpers & Strippers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Hand Crimpers & Strippers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
