This was purchased as a replacement for my Badger Million-aire compressor. The compressor is an ultra-silent very low volume compressor (0.7 CFM). So, low leakage was very important to me. Another bargain regulator which had been previously purchased constantly bled off air, which had kept the compressor from reaching its maximum pressure. This regulator regulated without a constant hiss and bleed. Although the fittings were 1/8 inch, they screwed into 1/4 inch holes, which made it a direct fit for my existing compressor. The pressure gage can be screwed into the left or the right side, it had to be moved from the stock position for my application; it was a snap to do. The actual regulation is very tight with little hysteresis. The small size makes it a snap to use it where space is at a premium. I recommend this product completely.Read full review
Verified purchase: Yes | Condition: New
I use my large shop compressor to supply air to this regulator for air brush painting. Works great.
Verified purchase: Yes | Condition: New
It works well but the fittings leak without thread sealant. Teflon tape is not enough to get a good seal.
Verified purchase: Yes | Condition: New
Perfect size for my silent compressor.
Verified purchase: Yes | Condition: New
Thank you I love it
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Systems & Sets
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Systems & Sets