 |
It has a good finish and a good fit. Be nice if the markings were outboard. That's the adjustment plates. The washer leaves one to wonder. Why didn't they leave as much material as the picture shows. The make sense picture. Instead it came with only half the oval. In the swing arm it still rotates enough to say. "Why not make it have the lip to fit inside the swing equal on both sides. So when its installed there is very little movement. Think I shopped Monday for a Friday part. That just ate up 7 hours pay. Trying to build a bike on a budget and saving up. On minimum wage. ot sure to install it. If its a defect what else could be turned out wrong of the mill? If its right, they cut a piece of metal off that's better left.
Verified purchase: Yes | Condition: New
I ride harder than most. Fit was perfect. End plates can't bow in as the stock items did, causing the axle adjusters to loosen occasionally. Same with the cap washer- indexed to the slot and dead flat on the surface areas where contact is made with the swingarm and the axle nut and washer. Parts are made from a much tougher metal than the stock items. I also made an improved spacer for the left side(see photo) with a broader contact area to the swingarm as the stock spacer dug into it, displacing its metal- this would be a welcome addition to the kit. Highly recommended.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Wheel & Tire Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Wheel & Tire Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
