This signal flasher unit makes installing LED signals a plug in switch rather than having to install balance resistors to make signals flash normally. And it's a simple plug in unit too.
Verified purchase: Yes | Condition: New
I installed LED turn signal bulbs on this Kawasaki Z650, and wanted to keep the stock blink rate. I bought this and installed it quickly and easily. On the '17-'19 models, the relay is located near the ignition switch. You need to remove the trim piece around the ignition switch with the four Allen screws on the perimeter of the piece, and it slides out of the way. The relay is on the right (throttle) side, and unclips simply. The new relay plugs right in, and slides in to the stock rubber holder in the same place. Before putting the trim back, turn on the ignition and check. Took about 10 minutes, most of which was removing the trim piece. This part has a good fit, and is well insulated for a rough life.
Verified purchase: Yes | Condition: New
Grabbed a couple parts from eBay but they were all duds. Put this one on and it fixed my problem perfectly. Been without blinkers for 9 months. Thank you all!
Verified purchase: Yes | Condition: New
Great product easy plug and play
Verified purchase: Yes | Condition: New
Slowed down the led flashing great. Easy to install
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Lighting & Lamps
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Lighting & Lamps