 |
These spindle shafts are much better wuality than the aluminum ones that were on the deck, because once the bearing goes, the housing is toast. None of these spindles are tapped, so I recommend that you buy the self-tapping bolts as well, and use some anti-seize lubricant when installing them, because the bolts can break on installation. Good quality and should last, but the zerks must be greased, because even though the upper bearing is sealed, the lower bearing is wide open inside the housing and requires grease, or they will fail rather quickly.
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New
Hit another small rock the same day I replaced the spindle! The pulley and the spindle shaft both stripped out again absolutely ridiculous this huskvarna part is junk
Verified purchase: Yes | Condition: New
The part was exactly as needed, however there was nothing stating that the mounting bolt locations needed to be tapped. would have been good information to know. Also would be nice if the mounting bolts were supplied
Verified purchase: Yes | Condition: New
Perfect fit, but may take quite a bit of grease to fill the void between the spindle and the cast housing. I would certainly buy them again.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Lawn Mower Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Lawn Mower Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
