 |
The end pieces that wrap into the wheel wells are not wide enough. If you've ever looked at a picture of the real prodrive p1 lip, or any other gc8 lip the back flange of the lip has a much bigger surface area to mount it to the back side of the front bumper. These just have about a 1" lip which creates a gap and leaves you with practically no flange to mount it. Whoever made this mold obviously never tried to test fit on the bumper. I rate it a 3/10 for this reason. If they had made the rear flange wider like any other gc8 lip I'd rate it a 7/10. There are also some wavy areas on the top edge of the lip that require some dremeling/sanding to clean up. I may try to find a plastic welder to add my own extra flange material on. Until then i won't be mounting this on my car.
Verified purchase: Yes | Condition: New
I definitely agree with the previous buyer's review. Both side end of the front lip where it attaches the bumper by the front wheels could have been better replicated. It is way short. I bought a better replica 10 yrs ago with the correct length on the sides. I would still recommend this lip due to the low price it was selling for. Could have been 5 stars if it wasn't for the side part being short.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Body Kits
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
