Had a small hole with a deformation in a rear bumper and filled it with the product. Note the product took a couple of days to cure vs the few hours stated on the label; this resulted in sagging as the patch was on a vertical surface. I sanded, reapplied and covered the patch with tape to hold the epoxy in position. Once cured the product could be sanded and painted. Finished product is tough and flexible - just what was required.
Takes days to cure. Way to runny to stay where needed.
Wanted to repair some small mounting brackets on the inside of a bumper that attaches to fender flairs. Should have been simple but this product would not cure and it just runs off the repair area. After a couple days I applied a second coat with gutters that I created with tape and paper to hold this product in place while it cured. This low cost product cost me valuable time and aggravation with a sticky mess that was worse to remove than to just keep going forward and hoping for the best. May work on horizontal surface where it can pool and stay put but will not stay on a vertical surface. It just runs off the intended repair.