I do both surface mount and through hole prototyping. These are the most used size I use. Via's are good quality. Small SMD parts can be mounted off the vias and .1 center connectors are mounting to a solid enough surface to be reliable. I have tried the cheaper paper boards and only use for minor projects. When you are prototyping, you are only limited by your imagination.
Verified purchase: Yes | Condition: New
I've ordered these a few times and they have become my 'go to' circuitboards for experimental stuff. They are really good quality and the holes are connected through but the end pads are not. This is excellent. I can really recommend these. Much better than those brown boards.
Verified purchase: Yes | Condition: New
This product is a low cost but very effective solution to a project I'm working on. I'm converting AC goose neck lamps to low voltage use by swapping out the existing lights with high intensity LEDs. I'm trimming these boards to fit inside the various lamps. Perfect.
Verified purchase: Yes | Condition: New
Good plating, solders well, clean. Everything for what I needed at the moment. Version with pads connected to end strips for use with small edge connectors would make them better yet.
Verified purchase: Yes | Condition: New
I use many proto boards for labs I put together for high school projects. Printed circuit board comes later after project is functioning properly. I can get messy with proto boards with single side copper. Pads peel off and very little stability with components that stand off the board. These boards have platted through holes. Very stable and allow for component removal without damaging the board. Highly recommend this product
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Printed Circuit Boards (PCBs)