Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Printed Circuit Boards (PCBs)
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Printed Circuit Boards (PCBs)
I used PNP blue film before the first try this paper. It works almost as well as PNP blue film but some working methods must be kept in mind! If it sticks to the printer (like someone said) then there is no paper error but the printer settings are incorrect! YOU NEED TO FIGURE THIS OUT! You must laser print, using the device "THICK media" settings! Then if you iron the paper to pcb blank then you get good result if you cool it down, then you do not need to peel paper out of the blank, it comes off easily by lifting off the edge and gently pulling it up (NO FORCE!). I didn't have any toner left on the paper (you need good toner magazine, not empty!), Xerox BW printer works great here, even small ones! If the techniques are right then there can be no problem here. Good alternative from one of the best sellers! 5*Read full review
Verified purchase: Yes | Condition: New
The paper is curled (rolled) up and it can damage your printer. It can stick on printers drum and will be difficult to take it out. It happens to me 6 of 10 times I tried so I cannot recommend it. Maybe if paper is not rolled can work but rolled one paper will never more be flat (straight). I succeed to make one easy PCB but it was not easy.
Verified purchase: Yes | Condition: New
Comes rolled up to a thickness of about a thick pencil. Even after spending a night pressed out under a stack of 6 reems of paper and being counter rolled it never was flat enough to feed. Eventually I taped a piece to a piece of card stock. Afterwards, the transfers were moderately successful.
Verified purchase: Yes | Condition: New
Excellent quality and very practical for make a DIY pcb. Thanks!
Verified purchase: Yes | Condition: New
good size
Verified purchase: Yes | Condition: New