Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Drill Bits
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Drill Bits
Initially I was skeptical of the quality, after all how could you get these drill bits so cheap? And in cobalt no less! Well, I took them in to work to try them out. I do mechanical repairs and welding in a large factory in the northeast US. The smaller drills at work are always breaking or "disappearing". I use these often to drill starter holes or as a "pilot" bit for much larger holes. One of these little bits plunged through half-inch steel plate in less than a minute with a Milwaukee hand drill. Like butter. There is no noticeable edge wear and is ready for more. Note that these are not full-length "jobber" bits --- they are starter or spotting drills. They are double-ended so you get 2x as many cutting edges, very convenient when one finally dulls off. Overall I'm thrilled with this deal, its an excellent value.Read full review
Verified purchase: Yes | Condition: New
Having a two ended drill bit saves lots of time looking for another one, if you break one, or just dull the one you are using.... I like having the extra bit on hand, and the same size too..
Verified purchase: Yes | Condition: New
Excellent bits for making pilot holes. The bits are short so when you insert into the drill chuck as far as it will go they only stick out about 3/4". This helps when the bit punches through, it does not break. Other bits stick out about 2 1/2" and break when they punch through know matter how hard I try to keep the drill level--snap. I needed to enlarge a hole for a deadbolt that would no longer line up where it inserts. Drilled six holes with one bit--didn't break!--and then used a step-drill-bit to enlarge the holes so all six pilot holes became one hole. Bit is still good. Other bits, I would break 1 bit for about ever four holes I would drill. These used in conjunction with a step-bit is a big money saver.
Verified purchase: Yes | Condition: New
This is the best 1/8" bit value that I have found in a long time. Excellent for wood or metal. I only wish it was longer so I could use it with my countersink over fitting.
Verified purchase: Yes | Condition: New
Have used others but these are great they don't break so easy
Verified purchase: Yes | Condition: New