Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Drill Presses
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Drill Presses
Lots to like here! The variable speed works smoothly and has the digital readout speed sensor. It runs smooth at any speed. Most of my work is done between 600 and 3000 RPM. I have literally no vibration or table flex. The laser cross-hairs are easy to adjust and hold position well. I find myself using this press more often than my floor model. This the first WEN equipment I have tried. I am happy with it and will buy again.
Verified purchase: Yes | Condition: New
Pro: Variable speed, laser aiming. Con: Variable speed is not electronic, it’s via tension lever on the belt. In 2020 you’d think they would have digital variable speed like my lathe.
Verified purchase: Yes | Condition: New
Very sturdily built, not too difficult to assemble, although it may be easier with two people as the head is quite heavy. I have only just started using this, so I may need to update in the future, but so far it seems to work very well. The speed seems to be easily adjustable, it gives you a little chart above the handle to show recommended speeds based on material and hole size. The built in light is also very handy for better visibility. I have yet to actually use the laser as I usually have my holes punched and just line the drill bit up before plunging it in, but it seems to be pretty accurate (it's adjustable I think). Was able to cut multiple holes with a hole saw at slower speeds and didn't have much issue, just had to take it slow going through the wood, but it managed it like a champ. I haven't used many drill presses lately for woodworking so i can't really compare it to anything, but so far it's doing the job I need it to, so I'm happy.Read full review
Verified purchase: Yes | Condition: New
Packaging arrived damaged but everything inside is OK. Goes together fairly easily (instructions have one minor mistake in a diagram). Lube as directed, it's important. Solid construction. Chuck is a nice size. Lasers crossing at the drill bit's POI is amazing. Drill needs a very stable base--if it's not lagged down to an even table top it can wobble a little.
Verified purchase: Yes | Condition: New
The Drill is of descent quality except for the chuck head of the drill likes to fall out every now and then even though I have followed the instructions for assembly. Really believe the Chuck head of the drill press needs to be re-engineered and staked better with either a key or bolt.
Verified purchase: Yes | Condition: New