 |
Teamed up with a cheap & cheerful B&Q compressor and some walnut blast media, I managed to remove serious carbon build-up from the inlet tract & inlet valves on a motorcycle. Also great for cleaning up aluminium and other soft metals without risk of damage.
Verified purchase: Yes | Condition: New
Obviously this is aimed at the DIY hobbiest but even with 120psi running through it with lightweight walnut grit it still failed to blast any media even though it's box states it operates between 50psi and 120psi. All i could get it to do was spit the odd grain. I fail to see how anyone could put this into practical application, if it fails to operate on compressors that match or exceed it's stated requirement specs. You'd probably need some industrial sized unit. The gun leaks and i had to seal the fitment threads to stop that. It's basically a plastic bucket with a hose fitting and a cheap sandblast gun on the end. I've never been so disappointed with a product.
Verified purchase: Yes | Condition: New
Not bad bit of kit used it to shot blast walnut to clean inlet manifold ports on my rs4 Don’t know how it would be for other media but did the job well
Verified purchase: Yes | Condition: New
I had some old stone fireplaces to renovated and re point , it did an amazing job .
Verified purchase: Yes | Condition: New
very hdone what i wanteappy with it only problem i see it takes a 200lt tank to run it well d
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Sand Blasters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
