 |
The product was delivered quickly and was exactly what I ordered. However, it is not an original Kenmore part and it doesn't quite sit flat like an original part. There are multiple hole attachments as the original only has one. You have to use it on a little bit of an angle and not straight back and forth. It works fine and is about half the price of an original part from the Sear's website. So as long as you know that when you make the purchase you will be satisfied with the attachment.
Verified purchase: Yes | Condition: New
Appeared to be of good quality until I tried to install it on my Kenmore wand. I had to drill a new mounting hole 180 degrees from the one punched in the lower neck of the brush. Original hole is on bottom of neck as shown in item photo, but is now on the top of the neck after drilling . If I installed the brush as manufactured, it would have been pointing up instead of down- great for the ceiling, but not so much for the floor ! Not a Kenmore OEM for sure, but after my new hole 'retrofit' -worked well . Poor quality control or design !
Verified purchase: Yes | Condition: New
I WAS A BIT WORRIED IT WOULD NOT FIT DESPITE THE CLAIM THAT SEARS CANISTERS WOULD BE COMPATIBLE. IT DID AND IT HAS BEEN GREAT TO REPLACE THE WORN OUT ORIGINAL. IT WILL HAVE BRUSH HAIRS ON THE BOTTOM THAT WILL ALLOW YOU TO GO OVER SURFACES AND NOT SCRATCH THEM. IT DOESN'T SHOW THE RING OF BRUSH HAIRS ON THE BOTTOM BUT THEY ARE THERE JUST LIKE THE ORIGINAL UNIT HAD. WORKS EXTREMELY WELL AT PICKUP.
Verified purchase: Yes | Condition: New
Their description of vacuum brush is accurate. Great size and functions well.
Verified purchase: Yes | Condition: New
Fits perfectly, looks just like the old one, except it does not say Kenmore.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Vacuum Cleaner Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Vacuum Cleaner Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
