CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Stepper Controls & Drives
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Stepper Controls & Drives
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
I had 2 shortcuts in the high side mosfet terminals. After removing the excess solder everything worked fine. I recommend proper visual inspection or testing with current limiting psu before connecting board to a LiPo.
Verified purchase: Yes | Condition: New
Bought 3 of these and I can't get any of them to work I have a 3 phase 500w motor. Motor works fine with 30a ESC but not with this controller. Not sure why? Wiring seems straight forward Connected pot to 5v and gnd - center pin to vr connected a 20k pot (5v, gnd and center pin of pot to vr)
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New
Mosfets are rated good but fail, regulator overheats even at 24V. Small capacitors overheat and fall off easily. It works okay on low Amps 36V or higher Amps at 12V.
Verified purchase: No
no brake, 5v ldo overheating. reverse not start before motor stop
Verified purchase: Yes | Condition: New
