this evens out the perfect biend of air/fuel mix,in return you get a faster responce of power and tork when needed,where as there conpeitiors are also rank equal in power rsponce,tork,price! they fail to mention the everyday tweek and peek to mantain these results.Edlbrock has low to no ajustments! my opinon is they are the best for your buck
Verified purchase: Yes | Condition: New
always a great product from the edelbrock group works killer on my 327. but to help futur buyers that plan to use aftermarket valve covers do yourself a solid and get the thick valve cover gasket edelbrock offers or the cover will hit the intake sides and not tighten down. found this out after trimming down the stamp steel valve covers i have and they still hit thick gasket installed does not hit.
Verified purchase: Yes | Condition: New
When doing a hot rod I have always used the alum. manifolds. Because of the weight they are easy to get off an on. The quality & price is good. When looking at used manifolds (alum) at swap meets, you see tons of spread bores & others. Very hard to fine A Edelbrock 2701, why its a great manifold.
Verified purchase: Yes | Condition: New
I was looking for this model Edelbrock Intake Manifold for my project, and saw this new, display model, which was never installed on a vehicle. It was missing the box, so I was able to save some cash on the purchase. It worked great!
Verified purchase: Yes | Condition: Pre-owned
Was expecting a used product at this price was pleasantly surprised to open the box and find the intake plenum was brand new still in its packaging! Great deal, light weight, the perfect piece for my '79 c10
Verified purchase: Yes | Condition: New
Great product, great price, easy fit coupled with a 600cfm Holley carb
Verified purchase: Yes | Condition: New
The intake is great and they do give you some gaskets but ,the gasket kit is not complete it does not com with the front and rear gasket that are usually made of cork i had to silicone it the gap is a little big hope it holds why give you only half a set of gaskets?
Verified purchase: Yes | Condition: New
Look good & will work great with my new fitec fuel injection systom
Verified purchase: Yes | Condition: New
this edelbrock intake is a very good intake for street rods or just to upgrade from your cast iron intake along with a edelbrock carb it gives very good combo for your sbc engine
Verified purchase: Yes | Condition: New
Fast shipment .. good quality .. I'll keep these guys in my folder of vender to use again
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Intake Manifolds
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Intake Manifolds
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
