Nice little extra to hang on to. soft rubber and the pebbles are not hard on the hands. I added a pierce floor plate to mt 10 rnd mag and it has a lip on it .so with the finger grove lip and the lip on the floor plate , you couldn't force this gun out of my hands. and it is really easy to hang onto when shooting. It is the perfect grip for my hands. as far s installation I put the front on about a 1/4 inch or so then stretched the rear on each time pulling it up and outward this stretched the grip a little, then working it up alternating front rear front rear. it went right on
Verified purchase: Yes | Condition: New
I have other Hogue Handalls and Hogue grips which were easy to install and worth every penny. The unit for the SigP365 is a great disappointment in that installing it requires crafting items from the plastic packaging. It then requires more hands, hand strength and dexterity than I possess to wrestle it onto the gun..Any prospective buyer should be warned how difficult it is to install. My Hogue Handall for the P365 has been relegated to the parts bin where I may someday find a use for it.
Verified purchase: Yes | Condition: New
After long consideration, and reading lots of reviews , both good and bad. I finally purchased a Sig P365. I took it down and cleaned and oiled it and went to the range. I then shot about 250 shells through it. 3 kinds FMJ, 3 kinds hollow points. It ate everything with no issues. I'm very glad I bought it. Dependable, accurate, easy to conceal. Only 1 issue as far as I'm concerned. The grip is a little small for a man that is 6' 4" and has very large hands. The remedy was the 12rd magazine and this Hogue beavertail rubber grip. Grip makes all the difference in the world. Adds a minimal amount to the circumference of the factory grip, but along with the extended mag. Turns this into a very accurate fun gun to shoot, yet still very concealable for pocket carry.
Verified purchase: Yes | Condition: New
These make holding a small pistol Much Easier ! They have a 'Grippy' texture to them and really improve the grip...they also last very well, and protect the guns grip from damage...I used this one on a Ruger .380 LCP Max because Hogue does not have one for it...and it's a near perfect fit for the pistol...I Reccomend Hogue for every gun !!!!
Verified purchase: Yes | Condition: New
I was a little skeptical about this handgrip. Yeah, it takes a little bit of coordination to get it on.... but I was pleasantly surprised at how comfortable and sturdy it is. I would prefer to wrestle it onto the gun rather than have it loose and flimsy. I have bigger hands and this (with the extended magazine base plate) really makes this a comfortable gun. Take the instructions with a grain of salt.... use a couple of plasticware knives, fork handles, or something of the sort instead of cutting up the packaging. PS... Using a hair dryer to warm it up first really helps.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Pistol Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Pistol Parts