 |
Perfect. I have the ability to make my own rails however the price of these makes my time more valuable . I can buy these and easily modify if needed. Shorten, add more mounting holes or whatever I want. You do need your own hardware and it comes with a premachined hole on each end. I happen to have plenty of hardware here so no big deal for myself. The price is fair and right where it needs to be for me to not bother milling a rail through my mill.
Verified purchase: Yes | Condition: New
Let me say first off this is just my opinion from my experience with this product and the specific use I was trying to achieve with it. I thought because of the low price I had found a steal on a length of rail I could cut to fit on a round handguard I had just put on a 300 blk build but after it arrived I found that it was considerably to thick and stood off the rail far too much. I had to chuck it up on the cnc and take quite a bit off to get the fit I was after. Considering the time I spent on tooling and fitting it would have come out cheaper to buy ready made sections for my specific handguard. However I will say that if you were looking to perhaps make short light mount sections to fit between the barrel and mag tube of shotguns this could work quite nicely as the fit and finish is terrific.Read full review
Verified purchase: Yes | Condition: New
it gets the job done. the finish is good, well made, clean cuts. if you spend 50$ will you get something better? perhaps perhaps not but this gets the job done and I would absolutely buy another and actually I just did.
Verified purchase: Yes | Condition: New
since century arms who makes the vska ak cant put some type of way to mount optics on the rifles i am making my own with your picatinny rail cut to length it will make 2 mounts the rail you sent me is perfect in every way and meets all of my needs thank you will order more if this works out
Verified purchase: Yes | Condition: New
These picatinny rail blanks are made of extruded aluminum and have the properly cut grooves in them to meet US M1913 and Weaver specs. The flat bottomed base is just under .500". The grooves are the proper width and spaced correctly apart. I installed one of my 45 degree scope adapters [shown in the pic] and it fit perfectly. These picatinny rails are exactly what I needed for my project.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Scope Mounts & Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Scope Mounts & Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
