|Listed in category:
Check the item description to confirm this fits your vehicle
Have one to sell?

1987 1988 1989 Toyota 4runner/ Pickup NEW Middle AC Vent (3D Printed) (GRAY)

US $45.00
Condition:
New
5 available5 sold
Shipping:
US $5.00 Standard Shipping. See detailsfor shipping
Located in: Round Rock, Texas, United States
Delivery:
Estimated between Mon, Jun 24 and Fri, Jun 28 to 43230
Delivery time is estimated using our proprietary method which is based on the buyer's proximity to the item location, the shipping service selected, the seller's shipping history, and other factors. Delivery times may vary, especially during peak periods.
Returns:
Seller does not accept returns. See details- for more information about returns
Payments:
      
Earn up to 5x points when you use your eBay Mastercard®. Learn moreabout earning points with eBay Mastercard

Shop with confidence

eBay Money Back Guarantee
Get the item you ordered or your money back. Learn moreeBay Money Back Guarantee - opens new window or tab
Seller assumes all responsibility for this listing.
eBay item number:266462958099
Last updated on Oct 24, 2023 12:34:16 PDTView all revisionsView all revisions

Item specifics

Condition
New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is ...
Brand
Preserve Rad

Item description from the seller

preserverad

preserverad

97.8% positive feedback
665 items sold
Joined Feb 2017
Usually responds within 24 hours

Detailed seller ratings

Average for the last 12 months

Accurate description
4.8
Reasonable shipping cost
4.6
Shipping speed
5.0
Communication
5.0

Seller feedback (121)

j***w (595)- Feedback left by buyer.
Past 6 months
Verified purchase
I ordered all four to replace the four vents, they look great and I am very happy with the look; however after you remove the clips from the old vents and try to install them in the new vents they will not fit. I cracked the first vent I tried until I got a caliper out and measured. They are all almost 1/16 inch too small. After some work with a Dremel to enlarge the opening they work fine but as delivered you cannot install the clips.
Reply from: preserverad- Feedback replied by seller preserverad.- Feedback replied by seller preserverad.
Hello, you are correct they are slightly smaller. This is because each hole on each vent is slightly different in size. We went with an all-around approach because some people buy clips later on or forget which clips go in which hole. This way no matter how you put them in they will fit. What I would recommend next time if you buy another vent from us, is just bend the clip slightly which should take less time than dremeling and create less mess.
u***s (1701)- Feedback left by buyer.
Past 6 months
Verified purchase
great seller
See all feedback