Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Printed Circuit Boards (PCBs)
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Printed Circuit Boards (PCBs)
Works almost as well as Blue sheet, the secret is to put a thick pad of paper under it that has been preheated with the Iron on the polyester setting, use a paper sheet over it snd use a lot of pressure, it will only take 3 minutes or so, take and put in the sink put dish washing liquid in top and water, tell it is all wet and cool, wait 5 minutes or so and wash off and peel off the paper, wash good as etchent dosent like soap much, this is fine pitch enough for SOIC. Note the paper is a little longer than 8.5 X 11" so you will have to cut off a little on the bottom.
Verified purchase: Yes | Condition: New
This was the first time I bought such kind of special paper and the results are quite good !... Usually I used Photo Paper to make the Toner Transfer to my PCB's, and it worked fairly good, but I notice an improvement when I used these Toner Transfer Paper sheets… I think I will start using only this type of paper in the future… Rui Martins Braga
Verified purchase: Yes | Condition: New
Gets very reliable toner transfers onto copper, brass and aluminum. Much more consistent that glossy magazine paper. Soak in water for ~5 minutes and it peels off gently.
Verified purchase: Yes | Condition: New
very good
Verified purchase: Yes | Condition: New