 |
1 oz is the perfect size for me, helps to reach hard places. Need some time to rate performance, but many of the top names in reel repair recommend, so I'm in.
Verified purchase: Yes | Condition: New
I've used Reel-X for around two decades in fishing reels and other gear. When I surf fish, my reels always end up underwater, and saltwater is incredibly corrosive. Reel-X protects the bearings and moving parts from corrosion. It rinses off fairly easily, which is a plus for me. Tiny bits of sand cling to the oil inside the reel, and when I rinse out the reel with freshwater, the Reel-X takes the sand and salt residue with it. After the reel dries out, I squirt in a few small drops of Reel-X, and I'm ready to go. I use Corrosion X for any lubrication job where I'd use WD40. It works better, and doesn't leave a residue that after time becomes gummy and clocks up.
Verified purchase: Yes | Condition: New
Applies easily if you cut tip off very close to top...cut too wide and you'll use too much.
Verified purchase: Yes | Condition: New
You want the best lubrication possible? Add Reel X to your arsenal. Maintenance to moving parts with Reel X will give your investment that longevity and performance you always want when fishing is that soul quenching past time. I use Reel X on all my reels because it works. Mark
Verified purchase: Yes | Condition: New
Been using this lube for years on my spinning, bait casting, and my wife's spin cast reels.( my 6 casting, 5 spinning, that are cleaned every year!) A couple of drops in the right places and your good to go.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Reel Parts & Repair
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Reel Parts & Repair
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
