Distributors & Parts for Mazda 323

Distributors and Parts for Mazda 323

Distributors and parts for Mazda 323s or GTXs can help keep your engine performing. Aside from distributor components that fit the Mazda 323 specifically, it is a good idea for you to purchase other items that will help you with proper engine maintenance, such as caps, gaskets, and bushings.

Since the distributor and similar parts are mechanical, you will need to perform routine maintenance on them and occasionally replace certain components. Distributor components are essential to your Mazda vehicle as they are responsible for igniting the fuel-to-air mixture that your car needs in order to bring power to the engine. A coil is connected to a rotor, which spins inside the distributor cap. This causes an arc of electricity to the spark plugs to start your engine. Because this discharge causes wear, you should purchase distributor systems and items that you can use to keep your engine at its peak.

You can purchase distributor systems for your Mazda 323 or Mazda 323 GTX in preparation for repair or replacement. These systems usually come complete with the requisite items you will need. However, it may be helpful for you to know and understand each of the respective components and their functions to save time on maintenance.

• A fully functional distributor system comes with the main performance parts as well as all of the secondary equipment you will need such as caps, bushels, and bearings.
• The distributor cap helps to distribute the current from the coil to the spark plugs and acts as a covering for the rotor and distributor.
• The ignition coil sits inside the distributor and is the part that will start the charge that is sent to the spark plugs via the cap.
• A rotor spins the coil past a series of contacts while the coil gives off a pulse as it passes over each contact. The charge continues down to the spark plugs to get your engine started.

If you need to perform routine maintenance on the distributor system of your Mazda, knowing how to swap out the distributor components is vital. While this is a relatively straightforward job, there are a few guidelines you should follow. You also need to be aware of the signs that your distributor components may need care or replacement. Cracks in the housing, broken spark plug wires, and burned cap terminals are all signs that you should purchase new components for your Mazda.

Here are the steps to take:

• First, remove the battery cables from your Mazda.
• Next, remove the engine cover and the air filter housing as well.
• Remove the spark plug wires and distributor cap.
• Remove the rotor screws and the rotor.
• For installation, start with the rotor, then the distributor cap, and then reconnect the spark plugs. Make sure you are using the new screws and bushings that you came with your replacement parts.