 |
They do serve their purpose well, the seal are bit more sticky than the originals, but those are things that you will eventually dial out with: air pressure, rebound and the type oil you're using. Theres just one particular issue to lookout for, and that is the crushers(plastic washers), they fit a bit too tight. This in turn, messed with the rebound adjusting. But other than that, they seemed to be holding up.
Verified purchase: Yes | Condition: New
Perfect fit for my 2012 Fox 120 32mm fork. I would recommend an installation tool with a pilot for getting the upper seals into the fork body. A small amount of suspension grease on the outside diameter allowed for easy installation with the piloted tool. The supplied crush rings for the (2) bottom nuts were correct and there have been no leaks when 8nm torque applied.
Verified purchase: Yes | Condition: New
Perfect fit for my 2005 Fox Float R Fork. It is hard to find parts for these older forks these days, but this is a great alternative and work perfectly!
Verified purchase: Yes | Condition: New
This is my first seal kit to purchase and install and so far it has done the job.
Verified purchase: Yes | Condition: New
Buttery smooth, best seal I’ve used
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Forks
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Forks
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
