 | Shop by category |
{"delay":300}
|
I just finished installing these extension tables. It was easy to install, and only took 20 minutes. I know they will be a great addition to my planer. more support for the wood going in and out of the planer. My old Delta planer had similar tables, so I think they are a necessity.The installation instructions were clear for installing the tables, but no where did they tell you that you had to adjust the tables for a level plane through the planer. I guess its makes sense that everyone should know this has to be done. So far, I'm super happy.
Verified purchase: Yes | Condition: New
Fits perfectly and was very simple to install on my DeWalt DW735 planer. Kind of hard to adjust and level to the planer bed, but eventually got it. The only thing I didn't like is how the one for the back of the planer can't really fold up and stay in that position for storage because the exhaust outlet on the planer sticks out too far. However, that isn't the extension tables fault, and the spring loaded nuts that are supplied with this product make it extremely easy to remove the extension table and put it back on. Highly recommend for anyone that wants to make their lives easier preventing planer snipe.
Verified purchase: Yes | Condition: New
I am very satisfied with this set of extension tables that I bought. They are very sturdy, so there is no concern for failure when using them. The only criticism that I have is about the fact that 735 surface planer should come with these already attached. After all, it is essential for the support of lumber entering an existing the machine to be properly supported for safety reasons as well as performance of the 735 planer to begin with. The installation of the tables is relatively easy, as long as you are mechanically inclined to begin with. Next time I buy a product the fine print should be read thoroughly.
Verified purchase: Yes | Condition: New
All thickness planers need an in feed and out-feed system to provide better snipe performance. These Dewalt Planer tables are easy to install, adjust and use. They eliminate almost all traces of snipe saving wood and time. Well worth the money.
Verified purchase: Yes | Condition: New
Ideally you want your planer to sit on a custom feed table where you can build stationary level sides. These tables are an affordable solution. Just be aware that you will have to manually adjust them to get level on both sides. Not difficult to do, but you will probably have to do it every once in a while to make sure that your tables are level.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Planers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Planers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
