Verified purchase: Yes | Condition: New
A very adaptable mount with applications beyond just dash cams (bikes & atvs for example). No ball joints that came with the mount were compatible with my Old Shark dash cam, so I used the ball joint from the OEM suction mount and placed a "little dab" of Goop inside each side of the joint holder to ensure a snug fit. Works great. Another suggestion is cut the spare rubber liner in half and drill holes to fit the bolts (on one side of each half - upper and lower) to keep them in place instead of fighting with them to keep them aligned when installing with the rubber addon. Bolts tend to be long and can be trimmed down CAREFULLY to ensure the wing nut still goes on and off. Great device and MUCH cheaper than Amazon was selling it for.
Verified purchase: Yes | Condition: New
The device is much too large for the rear view mirror. The modern mirror brackets are tapered, which is not very comparable with the attachment design l. I did get it fitted, tight against the back if the mirror which will have to suffice. It leaves the mirror unajustable though.
Verified purchase: Yes | Condition: New
I use a dash cam and in the south TX heat, the suction mount kept coming off. This works so much better. It's well made and it's kept my dash cam permanently mounted.
Verified purchase: Yes | Condition: New
Very easy installation, very flexible, can be configured in all directions easily.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in GPS Holders & Mounts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on GPS Holders & Mounts